QSpiFlash class¶

class QSpiFlash()¶

Initialize a a QspiFlash peripheral (external flash memory handled by qspi). This peripheral is available only for stm32l4 family chip and for Polaris device the auto_init is implemented (pins and memory data already configured).

To initialize a custom external memory qspi flash several params must be passed to the init method:

• Arguments

  • d0 – D0 pin of the Qspi peripheral

  • d1 – D1 pin of the Qspi peripheral

  • d2 – D2 pin of the Qspi peripheral

  • d3 – D3 pin of the Qspi peripheral

  • clk – CLK pin of the Qspi peripheral

  • cs – CS pin of the Qspi peripheral

  • flash_size – Flash size of the qspi flash

  • block_size – Block size of the qspi flash

  • subblock_size – Sub-block size of the qspi flash

  • sector_size – Sector size of the qspi flash

  • page_size – Page size of the qspi flash

  • dummy_cycles_read – Dummy cycles simple read

  • dummy_cycles_read_dual – Dummy cycles Dual flash read

  • dummy_cycles_read_quad – Dummy cicles Quad Flash read

  • dummy_cycles_2read – Dummy cycles 2read

  • dummy_cycles_4read – Dummy Cycles 4read

  • alt_bytes_pe_mode – Alternate Bytes for PE mode

  • alt_bytes_no_pe_mode – Alternate Bytes for NO PE mode

  • sr_wip – Write in progress of the flash mamory status register

  • sr_wel – Write enable latch of the flash mamory status register

  • sr_bp – Block protect of the flash mamory status register

  • sr_srwd – Write disable of the flash mamory status register

  • sr1_qe – Quad enable of the flash mamory status register1

  • sr1_sus – Suspend status of the flash mamory status register1

get_geometry()

Return a tuple holding flash geometry:

• flash_size, Flash size of the qspi flash

• block_size, Block size of the qspi flash

• subblock_size, Sub-block size of the qspi flash

• sector_size, Sector size of the qspi flash

• page_size, Page size of the qspi flash

write_data(addr, data)

Write data data starting from address addr. data can be a bytearray or a list of integers less than 256.

erase_sector() MUST be called before writing data in a sector.

Writing is also allowed via bracket notation. The following is valid syntax:

my_flash[addr] = data

erase_sector(addr)

Erase a whole sector passing the addr address of any byte contained in it. All sector bytes set to 0xff.

erase_block(addr)

Erase a memory block passing the addr address of any byte contained in it. All block bytes set to 0xff.

read_data(addr, n=1)

Read n bytes of data starting from address addr.

Reading is also allowed via bracket notation. The following is valid syntax:

my_data = my_flash[addr:addr+n]

** chip_erase()** Erase the whole memory. All memory bytes set to 0xff.

done() Close the QspiFlash peripheral.

wakeup() Wake Up the QspiFlash peripheral from sleep mode.

sleep() Put the QspiFlash peripheral in sleep mode.